OPAL CHERRY CAR KIT | ALPHA AUTOMOTIVE PAINT | BMW

August 27, 2025

Imagine cruising down the street in a BMW that doesn't just turn heads but stops traffic altogether. With our fresh Opal Cherry Car Kit, James Adkins ride transcends the ordinary, boasting a mesmerizing blend of colors that's as unique as it is breathtaking. James Adkins attention to detail and dedication to customization shine through every inch of this masterpiece, making it a true testament to the art of automotive design!

Installer: James Adkins

Coating: Alpha Automotive Paint

Car Kit needed for this look:

- Opal Cherry Car Kit (Black Ground Coat)

Like all of the Alpha Car kit Colors, Opal Cherry can be topped with Alpha Automotive Paint Clearcoat or other good UV-resistant clearcoats. This color is available in Automotive Paint & Aerosol Spray Cans as well.

This project uses an Alpha Custom Color basecoat, bound in a special binder for pigment control, UV resistance, and excellent pearl suspension. The basecoat mixes 1:1 with an AR-30xx reducer for smooth application and consistent coverage. Our AP-7541 DTM Primer-Sealer provides outstanding adhesion, flexibility and fast drying, while the AC-4521 HS Glamour Clearcoat adds long-lasting gloss, UV protection and durability.

Project Step-by-Step Guide

Complete your prep, body work, primer, and sanding following our video tutorials.
Block-sand the exterior panels with 320 grit sandpaper and scuff door jambs, engine bay and tight areas with a red scuff pad.
Blow off all dust outside and wipe down with wax & grease remover.
If applicable, paint the door jambs and engine bay first, then wait 24 hours before moving on to the exterior.
Re-mask and wipe down the project with anti-static wax & grease remover.
Mix and spray one medium wet coat of AP-7541 DTM Primer-Sealer (4:1:1 ratio) using a 1.4 mm needle spray gun.
After the sealer is 100% dry to the touch, wait at least an hour.
Mix and spray your basecoat colour directly over the sealer (most colours require 2–4 coats for coverage/effect).
Wait until the basecoat is dry to the touch before recoating.
After the final basecoat is dry, wait 45 minutes.
Mix and spray 2–3 coats of AC-4521 HS Glamour Clearcoat (2:1 ratio). Recoat when the previous coat is just tacky (fingerprints).
Let cure for 12 hours in a warm, ventilated area.
If wet sanding & buffing, leave masked for that process; otherwise unmask & assemble.
Enjoy your newly painted project!