OEM NISSAN MILLENIUM JADE | AUTOFLEX COATINGS | TOYOTA SUPRA A90 - The Spray Source

OEM NISSAN MILLENIUM JADE | AUTOFLEX COATINGS | TOYOTA SUPRA A90

The elegance on this Toyota Supra is now on another level! The guys at Get Dipped Services literally went all out and make this ride lights up the street and makes everyone stares at it when it cruises because of the new color it has that was achieved using our OEMatch Nissan Millenium Jade in gloss finish that is not a common color for a Toyota Supra A90! Classy looking color for an extremely attractive ride!

Installer: Get Dipped Services

Coating: AutoFlex Coatings

Alpha Automotive Paint needed for this look:

- OEMatch Nissan Millenium Jade

Like all of our other OEMatch, Nissan Millenium Jade can be used in Autoflex Coatings, Performix Plastidip, Halo efx, DYC Proline, bed liners, and other applications (test prior to use)!

This project uses an Alpha Custom Color basecoat, bound in a special binder for pigment control, UV resistance, and excellent pearl suspension. The basecoat mixes 1:1 with an AR-30xx reducer for smooth application and consistent coverage. Our AP-7541 DTM Primer-Sealer provides outstanding adhesion, flexibility and fast drying, while the AC-4521 HS Glamour Clearcoat adds long-lasting gloss, UV protection and durability.

Project Step-by-Step Guide

  1. Complete your prep, body work, primer, and sanding following our video tutorials.
  2. Block-sand the exterior panels with 320 grit sandpaper and scuff door jambs, engine bay and tight areas with a red scuff pad.
  3. Blow off all dust outside and wipe down with wax & grease remover.
  4. If applicable, paint the door jambs and engine bay first, then wait 24 hours before moving on to the exterior.
  5. Re-mask and wipe down the project with anti-static wax & grease remover.
  6. Mix and spray one medium wet coat of AP-7541 DTM Primer-Sealer (4:1:1 ratio) using a 1.4 mm needle spray gun.
  7. After the sealer is 100% dry to the touch, wait at least an hour.
  8. Mix and spray your basecoat colour directly over the sealer (most colours require 2–4 coats for coverage/effect).
  9. Wait until the basecoat is dry to the touch before recoating.
  10. After the final basecoat is dry, wait 45 minutes.
  11. Mix and spray 2–3 coats of AC-4521 HS Glamour Clearcoat (2:1 ratio). Recoat when the previous coat is just tacky (fingerprints).
  12. Let cure for 12 hours in a warm, ventilated area.
  13. If wet sanding & buffing, leave masked for that process; otherwise unmask & assemble.
  14. Enjoy your newly painted project!

Follow us on Instagram and Tommy Knows Paint for more projects and tips.

Back to blog