LEO-NARDO GRAY | AUTOFLEX COATINGS | AUDI A5 - The Spray Source

LEO-NARDO GRAY | AUTOFLEX COATINGS | AUDI A5

Check out this handsome Audi A5! Sprayed with our Leo-Nardo Gray Drop-In Pigment in gloss finish, this sleek ride is absolutely hitting the road differently by its look! Very interesting color that is matched with Audi A5’s exterior that are just shown in the photos and if you are familiar with this ride’s interior specs you will also say that our Leo-Nardo just fits and completes the killer and luxurious look and vibe this ride has! Killer paint job done by Rogue Enterprises!

Installer: Rogue Enterprises

Coating: Autoflex Coatings

Photographed: Zane Lacko & Autography

Pigments needed for this look:

- Leo-Nardo Gray Drop-In Pigment

Like all of our liquid pigments that include "Alpha Tints" , such as Pearl Enhancers, RAL Drop-In Pigments, and Alpha Drop-In Pigments, Leo-Nardo Gray can be used in Alpha Pearl & Candy Carrier or other traditional automotive paint, epoxy resin, Plastisol, Autoflex Coatings, Performix Plastidip, Halo

 

This project uses an Alpha Custom Color basecoat, bound in a special binder for pigment control, UV resistance, and excellent pearl suspension. The basecoat mixes 1:1 with an AR-30xx reducer for smooth application and consistent coverage. Our AP-7541 DTM Primer-Sealer provides outstanding adhesion, flexibility and fast drying, while the AC-4521 HS Glamour Clearcoat adds long-lasting gloss, UV protection and durability.

Project Step-by-Step Guide

  1. Complete your prep, body work, primer, and sanding following our video tutorials.
  2. Block-sand the exterior panels with 320 grit sandpaper and scuff door jambs, engine bay and tight areas with a red scuff pad.
  3. Blow off all dust outside and wipe down with wax & grease remover.
  4. If applicable, paint the door jambs and engine bay first, then wait 24 hours before moving on to the exterior.
  5. Re-mask and wipe down the project with anti-static wax & grease remover.
  6. Mix and spray one medium wet coat of AP-7541 DTM Primer-Sealer (4:1:1 ratio) using a 1.4 mm needle spray gun.
  7. After the sealer is 100% dry to the touch, wait at least an hour.
  8. Mix and spray your basecoat colour directly over the sealer (most colours require 2–4 coats for coverage/effect).
  9. Wait until the basecoat is dry to the touch before recoating.
  10. After the final basecoat is dry, wait 45 minutes.
  11. Mix and spray 2–3 coats of AC-4521 HS Glamour Clearcoat (2:1 ratio). Recoat when the previous coat is just tacky (fingerprints).
  12. Let cure for 12 hours in a warm, ventilated area.
  13. If wet sanding & buffing, leave masked for that process; otherwise unmask & assemble.
  14. Enjoy your newly painted project!

Follow us on Instagram and Tommy Knows Paint for more projects and tips.

Back to blog