DIAMOND BLUE PEARL OVER WICKED WHITE | TAMCO PAINT | CUSTOM TUMBLERS - The Spray Source

DIAMOND BLUE PEARL OVER WICKED WHITE | ALPHA AUTOMOTIVE PAINT | CUSTOM TUMBLERS

Check out the beautiful design done on these stunning custom tumblers by Apeelable Coatings that were made using the Alpha Pigments and Alpha Automotive Paint’s products! Our Diamond Blue Pearl over Wicked White was utilized first then topped with SoCal Blue Candy and finished with AC-4521 HS Glamour Clearcoat to create that detailed design and crazy good color combo!

Installer: Apeelable Coatings

Coating: Alpha Automotive Paint

Pigments needed for this look:

- Diamond Blue Pearl

- Wicked White Drop-In Pigment

Alpha Automotive Paint Products needed for this look:

- SoCal Blue Candy

- AC-4521 HS Glamour Clearcoat

Like all of our pearl pigments, Diamond Blue Pearl can be used in Alpha Automotive Paint or other traditional automotive paint, epoxy resin for woodworking and other art, nail polish, plastisol, Autoflex Coatings, Performix Plastidip, Halo efx, DYC Proline, waterbased airbrush paint, slime, bed liners, powder coat and MANY other applications! Take a look at our Alpha Pearl Mixing and Uses Page for more information!

Diamond Blue Pearl over Wicked White on Custom Tumblers


Diamond Blue Pearl over Wicked White | Alpha Pigments | Custom

This color is available in Automotive Paint & Aerosol Spray Cans as well.


USES: Alpha Automotive Paint, Custom Paint , Peelable Paint, Autoflex coatings , Nail polish , DIY Epoxy resin , Plastisol , etc.

This project uses an Alpha Custom Color basecoat, bound in a special binder for pigment control, UV resistance, and excellent pearl suspension. The basecoat mixes 1:1 with an AR-30xx reducer for smooth application and consistent coverage. Our AP-7541 DTM Primer-Sealer provides outstanding adhesion, flexibility and fast drying, while the AC-4521 HS Glamour Clearcoat adds long-lasting gloss, UV protection and durability.

Project Step-by-Step Guide

  1. Complete your prep, body work, primer, and sanding following our video tutorials.
  2. Block-sand the exterior panels with 320 grit sandpaper and scuff door jambs, engine bay and tight areas with a red scuff pad.
  3. Blow off all dust outside and wipe down with wax & grease remover.
  4. If applicable, paint the door jambs and engine bay first, then wait 24 hours before moving on to the exterior.
  5. Re-mask and wipe down the project with anti-static wax & grease remover.
  6. Mix and spray one medium wet coat of AP-7541 DTM Primer-Sealer (4:1:1 ratio) using a 1.4 mm needle spray gun.
  7. After the sealer is 100% dry to the touch, wait at least an hour.
  8. Mix and spray your basecoat colour directly over the sealer (most colours require 2–4 coats for coverage/effect).
  9. Wait until the basecoat is dry to the touch before recoating.
  10. After the final basecoat is dry, wait 45 minutes.
  11. Mix and spray 2–3 coats of AC-4521 HS Glamour Clearcoat (2:1 ratio). Recoat when the previous coat is just tacky (fingerprints).
  12. Let cure for 12 hours in a warm, ventilated area.
  13. If wet sanding & buffing, leave masked for that process; otherwise unmask & assemble.
  14. Enjoy your newly painted project!

Follow us on Instagram and Tommy Knows Paint for more projects and tips.

Back to blog